When he activated theft protection with CDC40 and CID does the tester said programming successfully.prprogramming successfullyogramming successfully
Hi. My friend had DVD90+Cid retrofited to his Vectra C.
When he decided to put CDC40+Cid. He deactivated theft prorection with opcom in both pairs, then put CDC40+Cid and activated theft protectiom. After that CDC40 had message HEADUNIT SAFE. If i remember correct after theft protection deactivation message always is DISPLAY SAFE.
After done this is impossible now to deactivate theft protection in Cdc40 and in dvd90, both units gives message Headunit safe. Is possible to fix this? I can read cid, dvd90 and cdc40 eeproms if needed.
Thanks in advance!
When he activated theft protection with CDC40 and CID does the tester said programming successfully.prprogramming successfullyogramming successfully
Don't know for 100%. He said that opcom showed OK.
And after few days he played and touched something in DIS programing, after that Headunit safe appeared.
Ask him to check code index, that there is no device present which are not onboard.
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
Decode Ghost (16th October, 2018), mancioks (16th October, 2018)
Here are dumps from DVD90 and CID.
DVD90 decoder shows for me ???? in pin and CID pin1949.
Thanks in advance
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
Albert G (16th October, 2018), mancioks (16th October, 2018), petronijul (16th October, 2018), TERNOCOD (17th October, 2018)
CAN configurations are the same, but still no success :/
Tried two opcoms and my own tech2. Can be the problem that DIS has active alarm ( "U2139 - Invalid data from cim" )? One time ago i couldn't pair UHP4 when microphone was disconnected.
hello,
i have a similar problem, i have unregistered dvd90 from the original car with code 7277, now i try to register on another car and it's not working. i get CODE OK message but it remains unregistered
here is the original dump with 7277 code and the unregistered dump.
DVD90_24c64_original_code_7277.rar
DVD90_24c64_unregistered.rar
can anyone help me with this ? Thank you !
you need register with code of display of another car
OPEL / SAAB EDC15M * PSG16 * EDC16 * EDC17 * DENSO * ACDELCO cloning / programming / resetting
yes, with the code of my car. i did that, code is OK but is not registering
At first check mid speed can configuration in EHU and DIS, must be the same like in car! (DIS present, EHU present, ECC, UHP and DAB present or not). You can register not divorced radio (not delivery state) only if you have DIVORCED (delivery state) display and code from radio. If you have both piece from another cars and not divorced you need to change eeprom in DIS or EHU to delivery state. You can check status n data blocks, also there is info about remaining tries to divorced and security time, if it is active you can do nothing (need to wait to inactive).
bank (27th November, 2018)
Bookmarks