2008-2009-2010-2011-2012 Chevy Malibu dashboad zeroing

**Kkrocky77** · 20th October, 2018, 02:14 AM

Hello everyone . Im a little curious on how i would go about on "Zeroing" a dash on 08 malibu
Original miles on bsi are around 140k but once modded through the 95080 it is at 101k . Dash displays 140,XXX would i need to zero the ENTIRE file or is there a certain section i would need to adjust . VERY much a newb in this ,so i apologize if im not speaking in proper terms .
Using Xtool xpad100 with the eeprom provided

**epd1221** · 20th October, 2018, 03:07 AM

U should do bcm only and that should do the trick ..

**Kkrocky77** · 21st October, 2018, 08:36 PM

Originally Posted by epd1221

U should do bcm only and that should do the trick ..

The car hasnt hit the cold pavement yet but as soon as get it running i will be sure to put up an update for those of you who are wondering
Thanks epd1221��

**Kkrocky77** · 31st October, 2018, 02:46 PM

Originally Posted by Kkrocky77

The car hasnt hit the cold pavement yet but as soon as get it running i will be sure to put up an update for those of you who are wondering
Thanks epd1221��

Solved .
Tachosft 23.1 has a couple of malibu options but none that actually gice off any resemblance to the lines given on 3c0 and 3d0 there really wasn't any patterns so to say . So I went through more of the options given to me and found a pattern that matched my dump from my 95080 chip in a 07 - 08 Chevy hhr . Typed in the correct mileage on tachosft , gave it to me . Flashed it then bam immediately showed up on the dash . So to summarize it all lines 3c0 and 3d0 weren't the lines that corrected the miles for me , 3b0 and 3c0 did .