Anyone help or suggest?
Hi their, i specialise in Volkswagen transporter vans t5 2003-2009 for customers.
When i change mileage through obd port does dashboard no problem, when i try to the ecu through obd. it reads it, then i write the mileage. takes a while goes through the procedure and then when finished reads it and its the same miles from before.
Is their another computer out their what can maybe do ecu correction through obd port for t5 transporters?
Maybe my digiprog3 is broke? its a clone but does lots of dashboards
Thanks, really appreciate it
Anyone help or suggest?
Disconnect the battery and connect again.
Use vag dash can or fvdi.
Do you reccomend vag dash or fvdi, which is better, and will they do edc / ecu on vw t5 transporter by obd? thanks
for edc15 and edc16 is best smok but all tools use same seed key and protocol for access to eeprom and flash area. if dont work one device it is little change work another.
good results on t5 with ultra cheap super vag k+can (the blue one)
(but be careful, i only use it for edc. Better dont use for dashboards. Very bad on Golf 4, T4, Audi a3.... )
sagie (17th November, 2018)
the blue one, the dash killer? you use it to change km in ecu, please tell how
So your saying this tool - https://www.ebay.co.uk/itm/New-Super...-/222929521953
Will do edc on a vw t5 from 2004 - 2009 by obd? im interested tell me more...
Yes, this one. EDC15+ECD16 i have good results. and yes, OBD. Need maybe 5 Minutes, if tool say "turn ignition off" - it count 30 seconds, then turn ignition on - finish.
If there is one failed, then VCDS is also not able to read current mileage.
Yes, the dash killer. I only use for EDC. Never kill a EDC. If not possible to read or change - nothing changes, no problems.
How? Like all other tools. Turn ignition on, Plug Tool with OBD, chose "mileage correction", chose "EDC". Then i chose EDC15xx oder EDC16xx, an press enter, and follow instructions on screen. Normaly it detects ECU, read mileage, and you have to enter new mileage. After a few minutes, the tool tell you to turn off ignition. Count 30 seconds down - turn ignition on - and press enter on tool. Reread with the tool - ok. Read after correction with VCDS - ok. (NOT ALL, i think, 80% it work. And it is a little bit faster then other tools i have for this... Even faster then digiprog, an more Versions covered then with digiprog)
English is not my first language...sorry
sagie (17th November, 2018)
ok, i thought you talking about older blue supervag
Just ordered this one - https://www.ebay.co.uk/itm/263576797817
Just hope it will do all t5's ECU mileage from 2003-2009 by obd
Thanks for your help dryka
Hi mate
VW T5 DIAGNOSTIC
The driver's footwell contains the diagnostic connection. Switch on the ignition on the vehicle. Connect the diagnostic connector and the DIGI PROG with the ST16 connector.
Now select the program: PKW / LKW - VW - T5 DIAG
The DIGIPROG indicates the old / wrong KM level.
Program the new / correct KM booth and you're done
Bookmarks