In case my help has been useful do not forget the magic buttons. ( Thanks and * Reputation ) !!!.
ATTENTION!!!
Attempting to clean files is only to help members. By using these files, you agree to assume the consequences and are aware that all liability for any damages is entirely yours.
Thank you!
megabits.
Your pinout...
Credits for @pinn...
In case my help has been useful do not forget the magic buttons. ( Thanks and * Reputation ) !!!.
ATTENTION!!!
Attempting to clean files is only to help members. By using these files, you agree to assume the consequences and are aware that all liability for any damages is entirely yours.
Thank you!
megabits.
damih (4th February, 2020), ervinhodo (16th February, 2020), fronzethenight (9th January, 2020), hmagga (2nd August, 2022), kinketotua (13th December, 2019), slick_dick (17th November, 2018), tom222 (9th December, 2020)
In case my help has been useful do not forget the magic buttons. ( Thanks and * Reputation ) !!!.
ATTENTION!!!
Attempting to clean files is only to help members. By using these files, you agree to assume the consequences and are aware that all liability for any damages is entirely yours.
Thank you!
megabits.
Did you try by op-com? I ask because op-com done crash by OBD.
the diagram looks good but i cant find ground I'm not very comfort withg this could use some help
If you will scratch the protective paint, at the point indicated in the picture, you will find a copper plate, that is connected to the GND.
But as bodzio012 said, why not try a COM COM, it can be simple and fast through OBD.
ervinhodo (17th February, 2020)
I get vcc overload what should i do ? and ye i lifted pin b5 and after i lift VDD
Last edited by ervinhodo; 17th February, 2020 at 04:30 PM.
Bookmarks