Motorola Cracker SW, please

[chana]

Thank you for the scheme. on work programs under OS WinXp just can not say. but I can say that the reset signal is exactly on any version of the program. I have one more question, if not remove the processor from the board and solder the wires only get to read and write memory??

[chana]

The scheme in MOTOR2_3.9.RAR by prusony should work, but I tried it with other similar program.

However, one more thing I would need to know. Can someone tell that all Motorola Crackers are compatible with Windows XP or not? Thanks.

With this design, and program eprom can read and write, you can also read the ROM. the only thing that MC68HC05B16 legs 22, 11 - the level of logic 1. 19 feet 10 volts. 9 feet land. According to another processor will not enter treatment.

[Mac Gyver]

Motorola cracker sw works fine in win xp or in win 98 ???

[Zmann]

Motorola cracker sw works fine in win xp or in win 98 ???

You comfirm that the SWs work with both Xp and win98 or just ask.

I so far get no success with these SW of all ver. with my XP SP3. I now put the project in halt, put them in the drawer and wait to get the right win98 SW to try again. My slow lownload not allow me to get it from internet.

[Mac Gyver]

I'm asking, because I'm not had sucess in making this sw work, but not tested in win98.
please anyone friend could expose a more detailed explanation how to make this SW work with these interfaces RS232?

[jawier]

Somebody have the interface for prog. the HC912

[Dunker]

Some non read problems are because the IRQ line can't be pulled up to 10v. Monitor this as you try to read the MCU.

[Zmann]

HC11s do not need IRQ 10v. I've done lot of tries, the final suspect is the OS and it was in my last question. If you got success with them, it's better if you could
confirm of what the OS you got success with.

[jawier]

Hey, why the Motorola BDM v2 have a hex for atini2313 20Mhz and in scheme uses a at90s2313 at 10 Mhz.
This is fake?

[Zmann]

Hey, why the Motorola BDM v2 have a hex for atini2313 20Mhz and in scheme uses a at90s2313 at 10 Mhz.
This is fake?

I think you can no longer get at90s2313, it's too old. That's why attiny2313. Attachment might help.

[micromax]

hello, this is very simple interface to program hc912. this is clone of TMW inteface, work 100% in attach sw+hw

[jawier]

How can i know which is the Xtal in this 8l0 959 655 g (bosch 0 285 001 352)?

[uk350]

maybe this one...

[Zmann]

That should be. But that is the type of a ceramic resonator replaced X-tal, I the first time see the ECU with a ceramic resonator instead of X-tal

[kasim_izmir]

How can i know which is the Xtal in this 8l0 959 655 g (bosch 0 285 001 352)?

Hi , 16mhz is usually for hc912b32
Also , here is good dump