Hilux 2018 C66 Timing Belt turn on

[Motocriss]

hi there, i have a problem with a hilux 2.5 2018, the problem is that i had edit the dashboard, my archive is correct but, now when i putted back the eprom c66, my dashboard does't work in ODO, and the led of timing belt was turn on, someone have idea of whathappened?
i will grateful if someone can help me

[junmab]

Write back the original file...

[Motocriss]

i did it, and i try with other dump, and the cluster doesn't run

[junmab]

OK .
Let me understand your problem:
The odometer shows but does not run.
The tripmeter runs as usuall.
The speedometer runs as usual.
The BELT light is now on.
It is well known problem with Yazaki dashboards that the odometer is not counting after altering the km.
Please send a pictures of the face of the cluster and the label with the the part number.
Please note: if you wrote back the original file but changed the km on it then this may be your problem. You have to write back the full original file untouched !

[Motocriss]

OK .
Let me understand your problem:
The odometer shows but does not run.
The tripmeter runs as usuall.
The speedometer runs as usual.
The BELT light is now on.
It is well known problem with Yazaki dashboards that the odometer is not counting after altering the km.
Please send a pictures of the face of the cluster and the label with the the part number.
Please note: if you wrote back the original file but changed the km on it then this may be your problem. You have to write back the full original file untouched !

Hello my dear friend how are you, check this photos you described my problem perfectly, the cluster's trip is working but the ODO doesn't have lecture, the T-BELT light is now on, the RPM and KM/H, Fuel level and temperature level doesn't move, just the ilumination and display is working i had reprogramming using the original file but the problem continues,

[Motocriss]

TBELT ON.jpgdisplay.jpg

[junmab]

You should check the soldering, the print and the small resistors near the chip. You must check that there is nothing that might shorten the pins of the 9386.
The problem you described is maybe because the mcu can not read the data from the 9386, therfore non of the gages are working.

[brend]

Without a dump, this problem can be discussed forever.

Maybe Mr.Motocriss ​start thread with both dump ori and modified!

[junmab]

I think he's got an hardware problem. He should inspect carefully the pcb.
If he would add the label with the part number, we could also locate an original dump for him.

[rtbdiagnostic]

try this dump ....

[junmab]

Motocriss, use the dump that rtbdiagnostic gave you without altering for new km. Just write it as it is and check if everything came back.
If everything will work well then you may alter the km.

[Motocriss]

Hello my dear friends, i repaired it, using the dump of rtbdiagnostic thank you so much, thanks to all memembers that was help me; i think that the original file was wrong when i read it, and i saved the modification in wrong mode

[junmab]

Thank you for reporting.
You should press the Thank you button for each of the members who have tried to help you.