domnloaded link tried to install says missing dll file deleted and tried to reload same message. thanks for the help
domnloaded link tried to install says missing dll file deleted and tried to reload same message. thanks for the help
Thank you MONDAO!!! My license is now until 2147!!!!!!!
Thanks for your help
my servicemaxx works well.
Hey Mondao
When checking cylinders you can perform injector disable test , engine running ,temp obove 160 .some will do auto injector test , some you have to do it manualy 1 cylinder at time (it kills fuel to the cylinder you are checking . A good cylinder will drop in RPM alot. (like bad engine miss).
when you have a bad cylinder say #2 all it means is that cylinder is not working proper.
Do Relative Compression test if # 2 comes up low , you will have to do manual compression test ( could be bad valves,piston /rings etc .
If # 2 come up good on manual compression test valve cover has to come off ,check rockers & valve springs if all ok probley getting into bad /pluged injector.
note I use Nexiq connector on Maxx Force engins I use 1939 protocol on all others I use 1708 .
Still lots of problems in Maxx Force software ,sometimes I cant get into ECM at all. Than I use Service Assistant with IC4 connector & never had one I can't get into . Yes I have updated my Nexiq drivers ?
I need your help
I have a nexiq usbbt, but does not work when I start the program servicemaxx this is what happens
1 - Progress Detection "initializing"
2 - Detecting Engine Type.
3 - Searching for Engine.
4 - probe switching protocol.
6 - Cable Not Connected.
try to run for 15 seconds and disconnect.
which protocol should I use? (Bluetooth).
MANY THANKS,
I JUST ASK IF IT WORK WITH IC4
servicemaxx try to connect, cant find engine
1994 t444, DIT, nexiq usb link, is the truck to old???
do i need different software???
any help would be appreciated
thanks
use MD32 to diagnose the 444 DIT engine its work very well .
Bookmarks