DId you just made this up? or did you ever tried it?Yuo must disconnect XTAL from Micronas
So you are saying: Remove the Hart of the patient, then talk to the patient whats wrong.
clip crystal to short pins ,or remove from circuit . 100% more accurate read/write
Hi all.
I have original XPROG-M.
- Micronas work fine , 1000% (test only Usb)
i read and writte ST10F280 ok. 1000% (Test only Usb )
Good tool
B.r
I check and re-ckeck the connections,ot's only 10 wires,not hard to connect,it's harder for exaple on some NEC processors from Renault dashes,so i think that the connections are the last thing to think,the problem is in that ID...
is not your hard or connections
you must set ID for mcu
I got same problem with mitsubishi M32C processor from car radio
ID don't mismatch so you can't read write
maybe exist special area protection in some mcu and you must
know ID
regards
the software set himself the ID,you select dash > car > Micronas model (3297,3217) and the read,so all you have to do is connect the wires and set up the program.
yesterday,another golf 2007,another ID problem,anyone else reporting that has such problem like mine?
thank you.
ID problem mean that you select wrong MCU type.Don't look on Dashboard menu as it is exactly,if you do Golf V,check mcu and maybe need to select Jetta -07.2006.On left panel you see type of MCU.
i have tested Xprog clone in golf 2007 cady 2008 and work fine
yep, us too...
stevan,very good ideea,i will try that.
Bookmarks