Never had this problem, but seems like you have a rare CPU ID.
you should request TMT to implement or download latest software.
Hello guys,my problem is for those who has an original Xprog-m programmer.Last days I have a dash VDO from a Golf V 2008,inside with a micronas 3297G and my programmer could not read/write the data inside chip,it's show an error "Device ID does not match,ID is 0x 000122B9".Someone has this problem before?an how it can be done?
Thank you.
Never had this problem, but seems like you have a rare CPU ID.
you should request TMT to implement or download latest software.
in the latest update from TMT is not specified any new resources regarding Golf V,only Caddy 2006,I sent them a few mails,they answer me but they are telling me to check connections,or the programmer start to read,bypass security bytes and then after 13 seconds,show that error with Device id...I'll expect news from them now...
I read and write is a very good Golf V CDC3297。
yes,i did too,and passat,jetta,but not this dash,from mexico,i thing there is something inside chip that x-prog does not know...
Did you always used a serial connection to x-prog?
trying to find any ERRATA for CPU ID change, but micronas is not open with datasheets.
Im sure its an ID change and not a change in Jtag security.
Do you have a rosfar R250?
no,I don't have,when I was buyed x-prog I was thinking that is the best tool for this job,but now I have doubts...
r250 no need ID?
No,
but maybe this one is implemented in rosfar.
Xprog is a great tool, but you should know that in this business we always need more tools for same job.
I buyed original Commander,they don't implemented yet the dashes with micronas so i thing to buy another tool for that,after i buyed xprog,now i must buy another,and so on....
I know my friend,
thats why I started to buy clones.
the fact is that buying clones,you don't expext much from them,so you can not be mad if the tool don't do that or this,but when you payd several hundred euros on one tool,it must override expectations.
Yuo must disconnect XTAL from Micronas
Hello,
i want to read ST10F280 did any one know wich interface or programmer do that.
Thanks.
Bookmarks