pin renault from dump

**gokey** · 23rd May, 2011, 08:59 AM

Originally Posted by andrze

I tried that but it doesn't work

Pin Code: 513AF07FBDEB

**albertros** · 23rd May, 2011, 09:01 AM

We have 3 conversations going at once here!!!

Reply to ninja

Hi,
Ok you may not have liked my answer but :-
You need to post dump from uch behind the clocks

Make a new transponder from the dump ( T5 ) = genuine zedbull tmpro etc.
That is if the remote key flashes twice when you push it.

It's a 4 digit security code on this vehicle.

This is the ecu theory :-
DCU3R
Immobilizer code is repeated twice; at addresses 0002-0003
(inverted code at addresses 0004-0005) and 0082-0083 (inverted code at
addresses 0084-0085). Replace existing immobilizer code at both places
with 00 00 and inverted code with FF FF.

**gabigafu** · 23rd May, 2011, 10:40 AM

For andrze: pin is 513AF07FBDEB

**ninja123** · 23rd May, 2011, 09:54 PM

Originally Posted by albertros

We have 3 conversations going at once here!!!

Reply to ninja

Hi,
Ok you may not have liked my answer but :-
You need to post dump from uch behind the clocks

Make a new transponder from the dump ( T5 ) = genuine zedbull tmpro etc.
That is if the remote key flashes twice when you push it.

It's a 4 digit security code on this vehicle.

This is the ecu theory :-
DCU3R
Immobilizer code is repeated twice; at addresses 0002-0003
(inverted code at addresses 0004-0005) and 0082-0083 (inverted code at
addresses 0084-0085). Replace existing immobilizer code at both places
with 00 00 and inverted code with FF FF.

LAST POST WAS FINE!!!!!!!
only asking as i have ecu in my hand, but van is far away.
as for your extended info about code, are you talking about ecu 25080 dump or uch? and what does replacing with '00' and 'ff' achieve?
Also, not understand the flash twice thing?? key is knackered, remote not worked for 2 years but customer been 'squeezing' key to start, but no go anymore.
ad manual says 12 digit code for programming new key.
Opened key but no seperate transponder inside, and lable to get emergency start code is rubbed clean!
Is there a carbon transponder that can be used for this?
I have a device to read the 12 digit pin codes, but my key supplier only lists a key that comes pre programmed at mega cost, many thanks, ninja

**albertros** · 23rd May, 2011, 10:40 PM

Hi,
this van is the same as the early clio 2
Uch on the van has a single blue plug
study the attachments
You need to make a new transponder with tmpro = T5 this will start the car.
The central locking will be un affected.
If you can get the key to work long enough to clone it that would do the trick.