VAG-COM/VCDS EVERYTHING

[ChopstiX]

read Info.pdf

Thank you, I already did and it gives no info on how to connect to the USBaspi ....
Or how to setup the programmer ....

[ChopstiX]

Holy crap what a messy setup In short, all of those are eligible for reflash.

Thanks send you a PM.

[kaalis]

Thank you, I already did and it gives no info on how to connect to the USBaspi ....
Or how to setup the programmer ....

There is pdf from Fantomel how to do it.
The rest depends from you.

[alin 151]

Hi!
I need help to rewrite my interface.
I accidentally ran the executable, not the loader!
Can anyone make a hex with my serial?

[hid3]

A hex with your serial? What do you mean?
What has actually happened?
Can you provide more details on this?

[alin 151]

Just what I said.
I ran the application not the loader.
In the autoscan, the message "not plugged into a car" appeared.
Yes. I want the same serial

[hid3]

So why don't you just reflash with Kolimer's once again?

[alin 151]

Because I already have one with Kolimer's serial.
This is taken from someone and has its own loader with the same update as Kolimer's.
The loader and the serial is valid from version 17.1.3 until today
If we solve the serial, I'll share the loader!!!

The interface cost 100 Euros.

[hid3]

At least you could post pics of the PCB of the interface so people won't be guessing on how to help you

[alin 151]

Believe me ... the interfaces are mostly identical.
Some good, some less good.
Other bad .... (NEC)
Important is the loader and the serial
However...

[rak183]

Hello,

is my interface a good one? there is no information on chip at the right side, how i can check witch one is it?
20180501_142958.jpg20180501_143030.jpg

[hid3]

Hello,

is my interface a good one? there is no information on chip at the right side, how i can check witch one is it?
20180501_142958.jpg20180501_143030.jpg

No, it's not a good/reliable one. However, it can be made better, it all depends on how much effort you want to invest in it.

[alin 151]

Ft232RL
Rewrite the interface and you'll see.
It will work!

[rak183]

Ft232RL
Rewrite the interface and you'll see.
It will work!

i found those information, but i cant decript those information.
FT.JPG

[hid3]

The FT232RL chip is cloned, that's why no markings on it. It is very poor quality, lots of communication errors, interruptions, etc.
For the interface to be reliable/usable with real-life tasks, you want to replace the chip with a proper one.

Also, your interface has got MCP2561 chip. This one goes to "sleep" mode. The firmware does not support that.

Long story short - you will have problems with this thing.