I have "SHORT TO +12V" FOR K1 after Test. Problem is not related to aftermarket radio as described on RT.
What components I need to check, replace?
I have "SHORT TO +12V" FOR K1 after Test. Problem is not related to aftermarket radio as described on RT.
What components I need to check, replace?
For #6086
Hello, you say this diodes is an electrostatic protection chip. before original chips not with this ESD, but later Microchip and NXP all with this electrostatic protection funciton.
Last edited by obd2cartool; 23rd April, 2018 at 11:42 AM.
Hi. obd2cartool #6093
Not sure I understand what you are saying here.
The Hex V2 cable you supplied me with does not have the diode. Do we need ESD diode - PES2DCAN,215 for can line protection or is it simply not needed?
Last edited by muscles1960; 23rd April, 2018 at 04:39 PM.
I think he means that the ESD diode is NOT needed at all because NXP1050 has already built-in ESD protection. As per quick look at the spreadsheet, this appears to be true.
I can calculate ABS module codings for:
* Continental/Teves MK60EC1 and MK60;
* TRW systems in Passat B6 / B7 / CC /Tiguan;
* MK100;
* Bosch ABS8.2, ABS9.0 and ESP8.2, ESP9.0;
* EBC 460 (UP!, Mii, Rapid, CitiGo, Fabia, Toledo, etc) New!
* ... and other VW/Audi/Seat/Skoda modules.I can assist with repairing \/CDS interfaces.
muscles1960 (23rd April, 2018)
Hello. I recently started receiving function requires licensed interface message while doing an auto scan. I think I may have accidently left the internet connected. I use version 17.8.1 that came with the cable. Pictures of my interface are attached. Can someone point me where to begin? Thanks
Your cable looks good, is x46 type and you can beggin looking for kolimer 6.3 zip file shared 20...or more pages earlier. Read info pdf file inside the zip... and try to flash by usb... if no succes with that method you need usbasp programmer. Just take some time to read...
hello,
ist there any guide how to flash with USBASP and Progisb?
i have allready a guide how to connect USPAsp to Atmega.
thanks
Last edited by rak183; 24th April, 2018 at 01:40 PM.
in fact is 44..
I had one the same.. was identified as 46 and was ok after flashing with x46 flash/eeprom.. or I just saw wrong...
identified as 46
This is the one I am talking about..
I can calculate ABS module codings for:
* Continental/Teves MK60EC1 and MK60;
* TRW systems in Passat B6 / B7 / CC /Tiguan;
* MK100;
* Bosch ABS8.2, ABS9.0 and ESP8.2, ESP9.0;
* EBC 460 (UP!, Mii, Rapid, CitiGo, Fabia, Toledo, etc) New!
* ... and other VW/Audi/Seat/Skoda modules.I can assist with repairing \/CDS interfaces.
Bookmarks