I had a problem with copying a 4C chip few weeks ago in key tool. I used the special Xhorse 4c/4d chip.
Set chip as 4c then copied onto the chip. It read ok in key tool, but not in VVDI2 or CN900 mini, and didn;t seem to want to start car.
I reset the chip and copied onto this chip again and it worked fine.
nagib (18th February, 2018)
nagib (20th February, 2018)
Maartinj to sniff data its realy hard, today i try fiat id48, sniff data like you said, but i sniff only 4 time. Where is the problem?
couldn't clone id46 HONDA BIKE key today -VVDI KEY TOOL after fail with sniffing- message on screen - "is it an original key?"
job done on first attempt using TmPro2 and 46 clonner with CN3 transponder.
zyjekrc51 (23rd February, 2018)
had same issue with id46 citroen after trying to sniff data had "is it an original key?" on screen.
when i had lower version it would clone fine but took a while to sniff data had to leave 3-5cm away from coil.
tryed many times with same issue. couldnt get it to sniff correctly. version 2.2.2
If i helped.... please dont forget to press the THANKS + REP buttons .
today i make a clone for vw golf 2011. first i clone it on keyline chip and from this chip i clone it with off line function of vvdi.
if have time ( kl cloning is 10 min and vvdi cloning 1 hour)
Last edited by kleidaras; 23rd February, 2018 at 03:24 PM.
newone (23rd February, 2018)
kleidaras (23rd February, 2018)
Me to. I use only for cloning.
Στάλθηκε από το F3311 μου χρησιμοποιώντας Tapatalk
I can't understand why vvdi the original chip can do only online. Keyline chip can do offline with sniff data from car. And China chip can copy direct with no sniff from car on 20 sec. All chip start Same car.
Στάλθηκε από το F3311 μου χρησιμοποιώντας Tapatalk
Bookmarks