Should be a diagram there somewhere
Hello, i have xprog v6.5 with dongle.
I need to read audi a3 8p dash with mocronas but on the bdm adapter i don't have the pinout what i need to wiring.
I have the bdm adapter with rev. C
On micronas wiring i need test 2, tck, tms, xtail2, tdo, but on my bdm adapte i have 3 GND, vdd, xclks,bkgd, extal, reset, vpp.
How to use this adapter, i worked with another programmers but with xprog is first time, i need to read cdc3217 from my dash to cahnge dump and mileage but i don't know how to use this adapter.
Should be a diagram there somewhere
i saw the diagram but on BDM adapter i don`t have the same pins, i post a picture with the bdm adapter.
On dash i need to use VDD, TMS, TEST2, TCK, RESET, TDI, TDO, VSS, XTAIL2, VSS but in the bdm i don`t have these pins, i don`t know to use this adapter
I posted a picture of the BDM adapter connection
I viewed, but on the adapter i don't have the pins mentioned.
I posted a photo with my adapter, can you draw me on the photo which pin what is please.
Last edited by hajlipaparli; 28th March, 2024 at 06:54 AM.
just use the diagram that i posted, the pins on the adapter are not all identified but they are correct, just use the pic i posted and you'll be fine
aaa, is not important what is printed on adapter. i thougt is was not ok the adapter, i was thinking not destroy the cluster ), i will try
Thank you!
I tried and works but now the problem is other...
I need to read the cdc3217 and eprom for safety reasons but the read is unable, is on grey.
The connections are ok because i readed the mileage, pin, vin, but i don't know why the read icon is on grey and unabble to read.
I need to read the cdc and eprom because i want to try another dump on my dash, and if is not ok i need the original cdc and eprom to remake
Bookmarks