Why you pfla 512kb. Not should be 1024 kb?
Hello friends,
This is the story:
I tried to read CAS4 F10 1L15Y with r270, the programmer has been stuck during reading. I waited a long time but r270 gives the screen ''WAIT''. So i plotted perogramma and tried to read it again but unforunately without success. I then went to the car and pluged cas back in, but the car did nothing at all.
I have now been able to read eeprom and flash with vvdi prog.
Can someone tell me whats going on ?
CAS4 1L15Y Continental 5WK49984JBR
Why you pfla 512kb. Not should be 1024 kb?
Renault ECU tool / IO terminal / A.S.W
you are so great keymaker but you don't know that cas4 1L15Y is 9s12xdp512 mcu with 512kb flash size?
I have only epron not have flash.. compare to my epron if its lookc fine:
shotaaa (22nd September, 2018)
shotaaa (22nd September, 2018)
I thing not good idea read cas4 with this tool.
Yeah I wonder why use R270 for this when you have VVDI Prog which is very good tool, for any type of CAS.
BTW. How much you paid for new CAS and how long you waited?
few years ago I try to read cas4 1L15Y mask with xprog with errors, then I try to read with R270 and after few terrible beeps and errors I came back to my old xprog and finished job without problems, of course I made some changes in connections and no more errors in reading-writing appear
I agree with "xyznia"
I have R/W eprom and flash, many cas-4 1L15Y with xprog and
no problems ,but you have to make right connection.
regards.
“The capacity to learn is a gift; The ability to learn is a skill; The willingness to learn is a choice.”
please post you connection's Xprog with CAS4
I always use R270 in CAS4 1l15y I never had a problem
p1et (24th September, 2018)
Carpenters, don't blame your tools . R270 can read that chip all day long, with no errors.
Bookmarks