Decode Ghost (26th April, 2018), username0815 (26th April, 2018)
First of all chech the state of new radio, if it's in delivery state, just pair with display using code 6467.
If not (I.D. OK), you should put in in delivery state, the simplest way is to write modified dump into eeprom
shooting posted for you dump, that is already paired with your display. Just white it into eeprom and "Plug&Play"
Last edited by bank; 26th April, 2018 at 02:26 PM.
Decode Ghost (26th April, 2018), username0815 (26th April, 2018)
bank (26th April, 2018), Decode Ghost (26th April, 2018), username0815 (26th April, 2018)
OK thanks than i will write shootings dump, thx for explaination
Hello Lads.
Radio Delphi CD40 Usb
It is any chance knows pin code and Deactivate Theft Protection and knows pin code
i tried one dump from some post here with deactivated Theft protection but dont know why, but radio BEEP what 5-7 seconds
will be the best if new file will be with GID 0610 code
Last edited by pocinas; 9th March, 2019 at 03:23 PM.
My post helps you? Please Hit Buttons
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
Last edited by pocinas; 9th March, 2019 at 06:33 PM.
My post helps you? Please Hit Buttons
cone96 (17th August, 2021)
P.S you is able do this the same With Delphi Grundig CD30?
My post helps you? Please Hit Buttons
Hello Lads again.
So can you do this the same in Radio CD30, Deactivation Theft Protection and i would like know PIN, PLEASE :-)
My post helps you? Please Hit Buttons
pocinas (11th March, 2019)
Hi There.
I need help (unregistering) with another 2 radios Delphi-Grundig Radio CD30 Mp3.
Will very greatfull for this.
My post helps you? Please Hit Buttons
Unregistered
pocinas (21st March, 2019)
I have the same problem!!! Can u help me? Please?
I read the EEPROM and through Pecky's program, it tells me that the code is the 6200.
But since I have this problem in the list, I can not access the radio properly so I can program!
I have OPCOM and VAUXCOM but I do not recognize the equipment.
I tried to choose the last CDC40 Opera that appears, I tried to unseal once with this code (6200) and said that it was done successfully.
The radio started again, but it stayed the same.
The message "DISPLAY SAFE" will continue to appear as before.
Because I had already misfired the CID with my old radio.
Someone can help me?
Or send me the .BIN file with reset done?
I would appreciate help with this and what steps to take with OPCOM to program properly.
Best regards.
Bookmarks