Oh my god
New problem
I puted a pin code for the machine and the code was 1951 .. now when i want to enter the menu and i put 1951 and ok
Nothing happen
Help pleass
Oh my god
New problem
I puted a pin code for the machine and the code was 1951 .. now when i want to enter the menu and i put 1951 and ok
Nothing happen
Help pleass
I found it
Its 123456 default code
Alice (17th November, 2017)
Question
When i try to update minicondor to 4.0.2
1. file (firmware)update ok
2. file (sd) start and get error
mashine start but when chose something on screen is big mees.
I put sd card in mashine and try update again but same.
Sd card must be formated or prepared to mashine recognise?
Or update kit is problem?
update by usb
thats the update 4.0.2
http://www.digital-kaos.co.uk/forums...7&d=1510658377
20171117_142309.jpg
probe brocken when i wanted to decode this key
from the first touch to the key
why thiss happen?
wissamshaat (17th November, 2017)
oh realy
i didnt knew that thank you
yes that right answer
i brocken 2pcs probe with this key and after that i understood how xc-002 work
DPF/EGR-OFF , TUNE , FLAPS/SWIRL-OFF , DTC-OFF........
wissamshaat (17th November, 2017)
Put in a metal key first.
Start cutting, pause, switch to plastic, and proceed with the cutting.
wissamshaat (17th November, 2017)
Yes, that works for cutting new key, however for decoding the plastic key that he is trying to do, it won't work on the machine.
Will need to decode by eye.
Only putting that statement up incase he misread your comment and try to decode again following your step, and break another tracer probe
wissamshaat (17th November, 2017)
thank you all
i will buy other probe and some drills
i had a code with that key to.when i tried to put the code it worked and showed me the same cut
but i did that only for trying and training
i didnt started to cut keys for custumers yet i am now in training only
and with the help of you all i will be good
thank you againe
Bookmarks