Are you for real????
Clean the blue crap off the chip and turn the clip around.
Hi,
I Have a Toyota Hilux 2007 that i need some help to adjust the mileage on,
The original mileage on this odometer is 236666 and would like to change it to 76389 since the new engine in it has this mileage.
Im using Digiprog 3 and im trying to connect Pin nr 1 to the backside of the odometer with any success.
I have posted pictures below since I think it may explain it better then I can.
Are you for real????
Clean the blue crap off the chip and turn the clip around.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
Untz (16th April, 2017)
The Blue crap is gone and i have turned the wires around.. But it is still not finding the chip..
Could you please elaberate how u mean how to desole this or make it with short connections on quarts?
Sorry im pretty desperate and dont know what to to so help me out if u can.
I have tried this but it can still not find it ...
it so easy remove the chip then clean it well after that try to read it as 16 bit
Everything will be back in order - All my respects to DK's members.
Untz (16th April, 2017)
Remove chip from board with hotair station (so is much safely), or with soldered iron (one side and later another side), clean the pin carefully and read chip. But this clamp from Digiprog set is real shit! Pay atention on this!
Untz (16th April, 2017)
you dont know how to use your own tools.....I think that is the problem
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ONLINE CAR FILE EDITION SERVICE
SERVICIOS DE EDICION DE ARCHIVOS AUTOMOTRICES
connection_hilux.rar
Hope these sort out your problem :
1. Check your clip's continuity if you persist on using clip, or
2. Connect adapter as seen in attachment by solderring
3. Do as Dr. Zoidberg said
Good luck & regards
learn, learn, learn
jomberykaso (13th April, 2017), mangolini (28th December, 2019), Untz (16th April, 2017)
This clip is a
Buy a good clip or remove the eeprom!
If i help, d'not forget to press thank button!!
Untz (16th April, 2017)
93c66
same as tundra 2007 and up
Untz (16th April, 2017)
You're welcome... next time try to press thanks button and/or add reputation, there are more than 1 respected member helped you already.
Can't say whether you ruined it or your DP is faulty, if you have other tool try to read c66 and post your dump here.
learn, learn, learn
Untz (16th April, 2017)
Sorry i did not mean anything bad.
Im thankful for all the help u have given me guys, but the pictures you posted maremuruk helped me the most since all of this is pretty new for me...
i dont have any tools.. what kind of tools whould this need, is it possible to fix this with the tool i have today?
Last edited by Untz; 16th April, 2017 at 08:24 PM.
Bookmarks