No problem to solder repair kit but be very careful with screws holding metal cover of ELV. Killed one by punching to much with little hammer to unscrew them
Hi to all dk friends
I have a 2005 audi a6 in garage today that has problem with esl .
Turn key in ignition but no lights on dash no start and no noise from esl.
I cleard the fault codes then boom lights on dash and car start no problem .
I see on ebay there is some repair kits for a6 esl and i am trying to rwpair it.
I was wondering if some one had done this job before and is it hard to do or is there any thing that i need to be aware of ?
Basically looking to hear from someone that experienced this before
Any help will be appreciated.
Thanks
Sent from my SM-G925F using Tapatalk
No problem to solder repair kit but be very careful with screws holding metal cover of ELV. Killed one by punching to much with little hammer to unscrew them
ramiz auto lock (22nd March, 2018)
Not at all. Just one relay and few microswitches as I remember. Only legs soldered to ground are little hard to desolder...
c47a4283bf39bd96566a618bb45b4074.jpg
when elv is open cut the red black wire and u will never have to worry about it
but steering will not lock againe
alclot (8th January, 2020), cipijoint (23rd October, 2019), Danielsach (17th May, 2018), HeXeN (21st December, 2018), lovinedi03 (8th May, 2021), ramiz auto lock (23rd March, 2018), rm23 (12th July, 2020), yugo45 (23rd March, 2018), _estima_ (9th March, 2019)
I get the steering lock to unlock when i put key in ignition switch, then i cut power red and black wire, but i still dont get ignition after turning key.
I noticed that when the remote locking function on key stops working, i cannot find kessy in vag scan.
Can this still be caused by faulty switches and relay in esl
Hit like and thanks if I've helped you!!
Better than that esl work for nothing... is this: replace the key reader. With a working one from scrapyard and you will start the car. Come back and post that i was right
immoneard (14th July, 2020)
Bookmarks