cleared
Hi
I have a A4 B8 from 2008 to cleare or repair the airbag light!
Have this errors on airbag! (in the moment i have problems with my tablet, that i use another OBD)
U1012 Supply voltage too Hight
B2000 internal control module memory checksum error
This car have Component protection and i need someone that have this problem and have it resolve!
or a virgin file or a correct file whose great!
thanks
einet
Last edited by einet; 13th October, 2014 at 08:26 PM.
I become the same error again and the checksum is gone!
But become internal module foulty and the "U1012 Supply voltage too Hight"
how knows more about this "U1012 00 [137] - Voltage too High" on audi airbags?
Hi , already have this fault ("U1012 Supply voltage too Hight") on a airbag unit and couldn't managed it
The solution was get one used and adapt component protection with VCDI
All of my posts are for educational purposes only.
If this was helpful to you, please press THANKS
einet (10th October, 2014)
Clear dump replace your ecu
Hi
Thanks,
But you say cleare dump and change ecu?
Is it correct that you say that i cleare the dump and load this dump to the new (sraped) ecu?
and this work whit component protection?
thanks
any sogetions for this problem?
And nobody that have AVDI can say somthing?
This is for a good frend of me, that help me.
thanks
Last edited by einet; 13th October, 2014 at 08:28 PM.
i have same unit with crc error..need asistance
Last edited by ecu; 28th September, 2017 at 01:02 PM.
Hi jruibarroso. I have a few questions. I´m triying to manage this airbag unit. Can you share how adapt component protection with VCDI? Can we change codification (I tried with avdi and vdcs only with and it disnt work? Can I do this only with unit?
Thanks in advance
Last edited by alclot; 24th January, 2018 at 06:47 PM. Reason: bad english xD
Hi again. Can anybody help with how change codification of this unit?
Please help ;(
Bookmarks