Hello
Help me Please
I do atmega 64 with upa USB erase error
Flash error
What is it problems?
Regards
Hello
Help me Please
I do atmega 64 with upa USB erase error
Flash error
What is it problems?
Regards
xprog avr.jpgI found this.
I updatre my years ago ,working good on XP ,and 7 64 bit.I try some 555 soft from net ,but no working good.I use this with internet ON with no problems.I manage to add atmega 10 ISP port on one side for reprograming atmega inside xprog and no open it.Inside there is two ping mark GND ,on my AVR 910 programmer is conection to be able to program atmega.For special case/fuse bit wrong!/ i add Xtal1 to ISP too,if i lock my atmega !Thanks LAndre and Adam 28 for good JOB!!!But i was try to read MPC 551 ,read all ok /edc16c34 KIA/ then erase flash ,erase eeprom ,then try to write flash and there is error on 80,68,98 % -writing failed!Conection is standart BDM Bosch with ext 12 volt.
I have updated and now I have the error unknown command software error
hello all, please does someone know the pinout connection and lockbits, fusebits configuration to read atmega64 and update my XprogM with upaUsb .
If you can not fix it, please leave it as it cameIF I HELPED YOU PUSH THANKS AND REP BUTTONS
I have update to 5.51 and all work, but i must restart software every time if i read one time. If i no do it hangs on reading. What is wrong?
function?or not?
Hi, I am asking for 5.5.1.txt I can not download it. Thank you in advance
thanks, hope will be helpful
Hello Adam, I was able to update but when I read any memory it gives me a message from unknown command, software error, do you know how I can solve ?? my xprog-m was version 5.84 clone but I couldn't find the certificate anymore ...
Thanks!!!!
I'M GETING A PROBLEM WITH ME I NEED TO DO WHAT HELP
Bookmarks