I've worked for two and more years with Autocom CDP+ Clone with 2012.2.


Now I installed 2013.3 and tried to update firmware but without successfull. Gives error that firmware is not up to date.


After that I tried to update firmware back on 2012.2 and all red leds were on. But also on this version that worked before it gives me error and now have a big problem.


When I plug OBD connector to car, red led lights only blinks and goes off.


I tried with boot mode, solder wire to ST processor pin 138 and 108. Red lights are on, downloaded 2012.2 firmware to autocom is successful with Flash Loader Demonstrator, but again leds only blinks when I plug OBD.


Solution ?