So it can not solve the problem
copy paste eeprom not work in pcr2.1 -Luckily-
hi to all
here is the history :
I HAVE vw touran 1.6 with pcr2.1 damaged (2012) transmission automatic (7 rapports)
i get another pcr2.1 (already used in other car),getting the pin/CS and successfuly adapted to the car using avdi original ( hardware number different only in last 2 digits)
after adapting to the car the safe mode gone but car not start,bcz this ecu is for car with manual transmission i tried to modify the coding to automatic but always failed with abrites and vag clone i am not tested with origial vag-com
so i flashed the new ecu with same software number of the damaged ecu using abrites online flashing
the car start but the coding become 00000000000 no coding
i come back to its original software ,again car not start but recover original coding
i heared that to modify the coding of pcr2.1 must edit mileage in the eeprom less than 100km
is that true???
if i read original eeprom and flash of the damaged ecu and write in the new will that work??
plz need ur suggestions what must i do exactly
any help i will be appreciat
thx in advance
So it can not solve the problem
copy paste eeprom not work in pcr2.1 -Luckily-
bcm2 elv adapt online offline -echange immodata -clone immodata sinchro bcm elv medc17 edc17 Crafter EZS e EDC17 sinchro -DPF/ EGR/ DTC/ removal/: IMMO ADAPT edc16 EDC17 edc17c64 C74 NOW WORKING MED17/MEV17/ VAG ecu clone full working all
PCR2.1 FULL CLONE ou adapt, clone all edc17 me17 , etc / dash echange immodata repair immodata add key etc etc
toutougsmserver (20th August, 2017)
thx for answering me
now i find another ecu with transmission auto 7 speeds,i adapt it now car start without problem,but i have other issue my new ecu have start-stop and speed regulator option wich not available in my car
reading dtcs in ecu:
problem comunication with abs
problem comunication with steering
relais start-stop
problem regulator vitess
but the car is runing without problem and no lamp in instrument
is it possible to modify the coding to remove options wich not available in my car???
or just remove dtcs from ecu will work???
thx u
any one can help me on this pcr2.1???
coding this ecu need any security code to access???
if any one have experience with this ecu plz try to help me
post stickers of ori and used ecu.
Auto Locksmith,Tuning,Dpf Removal,Dtc Removal,Immo Removal,Ecu Adaptation,Crash Data-Clear.
Hi , i ve a similar problem.
I ve clone a pcr2.1 with x17 magic motorsport
So I ve written eeprom mod dump and odx files sent by magicmotorsport service.
Car Start well but coding become 000000000... and preheat lamp is blinking
So I just put back the coding from the original ecu. Coding accepted. But now Car starts and stop few second later and unable to start again, shut down power written on dash.
Fault code tells coding error
Dont have any coding helper to try antoher coding
Does anybody have solution ?
regards
Bookmarks