Here is the flash.
Here is the flash.
Good morning everyone. Mr. Vlaki: I am not able to open and extract the content of the file, because it is locked with a password. This is what I requested for in the last post.
Last edited by Ter; 23rd September, 2018 at 09:58 AM.
The file worked! My car starts now and doesn't go off again! I truly appreciate this great forum. One of the good things that happened to me is to discover this forum.
Now, what is left is to recode the ECU. Can someone help me with the engine code for Audi Q7 4.2 V8. The original ECU that came with the car is 4L0 910 560 C.
The year is 2006
Last edited by Ter; 24th September, 2018 at 12:55 PM. Reason: Year of car
Hello everyone. I hope everyone is doing fine today. Please can someone help me with immo off for the attached eeprom. It is for 4F191560A.
Many thanks in adance.
Ter (28th October, 2018)
Hello everyone. Please is it possible for an immo off Med 9.1 Q7, A6, C6 ECU not to work in another similar car after immo off worked on the original car?
Why I ask this question is that, I did immo off on the ECU, and it worked fine in Audi Q7, but not in another car. The second car acts as if there is active immo. It starts and goes off.
So I want to know if I need to immo off the ECU a second time.
Thank you in advance.
Last edited by Ter; 16th November, 2018 at 07:51 AM.
Someone please help me with immo off for this file. It is cloned from a bad 4L0910560C ECU to a 4F1910560A.
Thanks in advance.
Last edited by Ter; 21st November, 2018 at 06:19 PM.
Ter (22nd November, 2018)
#3
Less than 1 minute ago
Hello everyone. Hope all are doing fine.
I will soon give feed back on the immo off file that Nickolasd helped me with.
Please I have a new question:
If all keys are lost on a Passat CC 2009, and I do immo off, will car start and run without learning the new key?
I have tried to learn new key, but my lonsdor k518ise keeps saying no 'key present'.
Car starts and runs for some seconds, then stalls.
I will appreciate help grately. Thanks in advance.
engine may run(test it and see what happens) but you will have warning on a dash for key not accepted and steering column locked. make proper key, key should be precoded with data from dump and then programmed, have done them long time ago don't remember details.
Ter (25th November, 2018)
You are right sir. It finally worked for me too.
Last edited by Ter; 25th November, 2018 at 03:31 PM.
Bookmarks