hi all I have a Vectra c that needs odometer correction
I have an obdstar x300m which I don't think will work but also have a carprog running v8.21 aoftware
will either tool do it?
if carprog can anyone give me any tips?
cheers
hi all I have a Vectra c that needs odometer correction
I have an obdstar x300m which I don't think will work but also have a carprog running v8.21 aoftware
will either tool do it?
if carprog can anyone give me any tips?
cheers
eeprom programmer and hands
if i can solve your problem, please use Thanks and Rep button
ok
will my carprog do that then?
I think I need a pdf or how to guide as it will be my first attempt?
I take it I just need the clocks in order to make the change and de solder the corret eeprom?
cheers
Carprog should do it
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
Carprog is ok for the job.
Vectra C has 93c66 eeprom under the mileage display. Desolder the chip from board.
Mileage stored also in ECU or PSG16(2.2DTI).
So
Desolder chip from dash and then my carprog clone should be able to do the job?
When i do it il posg some pictures up before i go ahead to make sure what im doing is right or does anybody have a good link i can follow and see how its done?
Cheers
PIC FROM ENIGMA
doest need de soldering or can it be done with the chip still soldered to pcb?
is this the same process for astra h as I have some astra h clocks to practice with aswell
cheers
Desolder it mate
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
Ok so desolder and read with eeprom reader
Maybe a silly question but how do i know what way round to place eeprom in reader pins for car prog?
And then how do i go aboutfinding where in the read the mileage is stored and editing it?
Cheers
Carprog will say what it is in km
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
Eeprom pin 1 is either marked with a dot or if one side is wedged angle with it facing you pin 1 is left side
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
What way round in the eeprom reader does the chip go or is it labelled/self explanatory when i try to read?
Bookmarks