what problem are you having with that ECU? According to the part number on that ECU and also the VIN number shows to be a 2013, I should ne able to get you the pin out
Jeep wrangler rubicon (JK)2014
3.6 lt pcm JTAG MPC5566MVR132 pinout needed
Part :
P05150 722AC
CONTINETAL CORPORATION 284146150330
(
Continental GPEC2 )
THANKS
Last edited by vanos batam; 20th October, 2017 at 01:39 PM. Reason: Continental GPEC2
_______________ D3-oToprog _________________
ig : vanos_batam
what problem are you having with that ECU? According to the part number on that ECU and also the VIN number shows to be a 2013, I should ne able to get you the pin out
Last edited by Plcautoparts; 22nd October, 2017 at 09:38 PM.
A simple thanks would do, If it didn't work at least I tried.
vanos batam (23rd October, 2017)
Nothing problem
Just wanted the pin Jtag for cloning the ecu and remaping.
Regard
_______________ D3-oToprog _________________
ig : vanos_batam
Here it is , good luck!
A simple thanks would do, If it didn't work at least I tried.
mihac (20th November, 2021), neutec (20th September, 2020), vanos batam (26th October, 2017)
IMG_20180424_215415.jpgthis is jtag port on this ecu. none of tuning hardware is able to read it for now. Even russian bitbox reads only partial flash. on;y way to clone is move eeproms.
vanos batam (16th August, 2018)
bitbox not work !!!!!!!!!!!! this ecu
update:
will work if it same HW and SW number...(for clone )
Last edited by vanos batam; 12th April, 2022 at 01:37 PM. Reason: update
_______________ D3-oToprog _________________
ig : vanos_batam
I think Bitbox should be able to read it according to this ---- > http://bitbox.ru/en/catalog/10
Can someone confirm
yes work fine ...http://bitbox.ru/en/catalog/10
Bookmarks