upload flash
upload flash
flash uploaded
Unfortunately can not write this file back with my KTAG clone ,
its showing that is writing and process complete successfully but when i read again to verify the original file is there.
I tried to write a few times with the same result
the KTAG read the eeprom two time
when it writing its ok but when verify not ok
If I helped please press rep + thanx
the KTAG read the eeprom two time
when it writing its ok but when verify not ok
the org eeprom size 1.0kb
but the ktag read it 4.0kb
If I helped please press rep + thanx
can you clarify what you are saying? You mean that when I write it, it does it properly even though when I try to verify it says its wrong?
YES that what i say
If I helped please press rep + thanx
koziolek (14th February, 2018)
So you sure I can do now drive authorization and it should start.
how about vin number is still showing original vin from donor ,how it will change
do I have to do on line SCN coding or not
if you whant i will send you zero file no vin
you write it in eeprom 95080 by any programer like carprog or any tool
but you have to remove the eeprom from ecu boord
only eeprom you need
Last edited by huzefa; 15th February, 2018 at 01:12 PM.
If I helped please press rep + thanx
back to square one, ECU replace same errors there
1200 ,0649, 0641, 0633
when I erased errors they came back in a few seconds
when I check live data in scanner exhaust camshaft sensor for bank one, the value does not change it looks like its frozen,
The other 3 sensors acting in specification
switch sensor position same result.
check wire continuity all OK
remove all camshaft sensors to check timing position all marks in center for both banks
check with scope camshaft exhaust sensors for bank 1 and bank 2 .
Bank 1 its yellow , Bank 2 its green
bank 1 sends signal but when scan it ,scanner does not see any reading from that sensor frozen -20 .
Last edited by koziolek; 19th February, 2018 at 01:07 AM.
Check balanser sprocket.
Wysłane z mojego SM-G390F przy użyciu Tapatalka
ok but why no reading from exhaust camshaft sensor ?
i always when p1200 in m272 , disassemble right valve cover and endoscope look for balancer shaft
Bookmarks