I think winols can see table off dtc
but need damos
hi friends i look make manual dtc remove
post here all info for this proposit
when have more info tested i can make software in c or python
free 4 alls
__________________________________________________ __________________________________________________ _________
for bosch edc16 i read this info is correct?
Make the following calculation:
( addresses of the first occurrence - address of the associated DTC table) / 8 = index
__________________________________________________ __________________________________________________ __________
for siemens sid
search dtc in hex and move octal(00 00 00 00 00 00 00 00 ) change value 01 --> 00
example:
p0489
0005DED8 04 89 00 00 00 00 00 00 ‰
0005DEE0 00 00 01 00 04 90 90 83 ƒ
0005DED8 04 89 00 00 00 00 00 00 ‰
0005DEE0 00 00 00 00 04 90 90 83 ƒ
__________________________________________________ __________________________________________________ __________
Last edited by reproteq; 21st April, 2017 at 12:58 PM.
I think winols can see table off dtc
but need damos
there are Two solutions in ols to find the dtc easy
and there is also the gouv software that tell if a dtc is on or of just applying the flash file it's says for each dtc coded by the car manufactor if it's on or off so then they can make a ticket to the seller of cars that are DTC off
ok thanks by your info
but is posible post more info for advance in this project?
Bookmarks