i had same problem and solve it with capacitor change
autocargo (31st March, 2016)
Replace six capacitors. Show in the picture.
I have similary problem but I also change the MCU yesterday
Capacitor change should do it if i read correctly
hello to all
thank you for sharing
i have two xprog i need to programme Motorola MCU MC68HC11E9 4E28B
i see this vcc pin overloaded
xprog-m and xprogbox same probleme
any idea
best regards
Hi to all friends. I have xprog m 5.5.1 . Always was good. But now when i try read tms i got low voltage error. With serial eeprom everythin good. Any solution?
External pover 15v ?
Always was good with 12 v power. Now i just buy 15v power and now reads egain. Thanks
I had the same problem while reading an hc11c1 in-circuit. It was a bad selected pindata connection.
locksmithpro (8th July, 2022)
Bookmarks