Jo Pi
8th January, 2023, 01:46 PM
Hi all,
I need help for EPS ECU 8200294976 on Clio 3 (2006).
My EPS column has been replaced by second hand spare on which VIN was written and immo off was set. The wheels were straight and the steering wheel well-adjusted when mounting but I didn’t see any marks on steering wheel column to set it.
The car starts, steering wheel assist works, no light on, drive 20km but ECU angle sensor value stays at minus 0.1° and status indicates “angle sensor calibrated but not initialized” (torque sensor value is ok) when I read then.
Can anyone tell me how to initialize the angle sensor (procedure, etc)?
Thanks, by advance.
I need help for EPS ECU 8200294976 on Clio 3 (2006).
My EPS column has been replaced by second hand spare on which VIN was written and immo off was set. The wheels were straight and the steering wheel well-adjusted when mounting but I didn’t see any marks on steering wheel column to set it.
The car starts, steering wheel assist works, no light on, drive 20km but ECU angle sensor value stays at minus 0.1° and status indicates “angle sensor calibrated but not initialized” (torque sensor value is ok) when I read then.
Can anyone tell me how to initialize the angle sensor (procedure, etc)?
Thanks, by advance.