Pcr 2.1 Need help

[Quattro1111]

s it possible to set idle speed on 1000 rpm because the car is shaking below, and make a healthy stage 1 on it?

Thanks in advance

[duddy]

First, bring the car to the correct condition and then do the stage​

[Quattro1111]

I thought that stage 1 is without optimizing the physical components.

[smokin66]

if car shaking i would do injector test as these are prone to failure and normally only last 50,000 miles,or do injector deviaton with vcds
once car running ok then might be ok for stage 1

[supremeza]

also you only need to post one thread you have posted 3 threads for the same issue

[Quattro1111]

I made injector deviation already and cleaned all 4 injectors. I wang to try it with 1000 rpm idle speed

[Quattro1111]

yes exscuse me i thought tjat they dissapear in a few hours

[kammykhan]

The car should be idling smooth around 700 - 850rpm. if you have a shake then check your injectors!!
Do not just raise the idle rpm. Dont be lazy fix the car first.

[dpreprotechnik]

Mate I had the same issue on two different cars, both 1.6tdi w Continental management. 105ps CAYC engines are prone to develop wear on the intake manifold gaskets (the orange rubber ones). They shake at idle and run well on every other rpm range. While idling, apply some force down into the intake flap (TVA) with your hands (put a good amount of weight on it). If the engine stops shaking, then check your gaskets.

Check also your rail pressure sensor connector, I have seen some of them fail, but you should get a DTC occasionally.

Regards.