PDA

View Full Version : Tinysweeper, ATtiny2313 state changed



Zmann
10th March, 2010, 02:33 AM
Hi mate, Ive made up the tinysweeper using ATtiny2313-20PU and programmed it with the TMW dump and the wire setting according to the image . Every thing works fine except after several use by pressing the reset sw. the device changes state, the led changes from normal to brink all the time. Take the ATtint2313 to read again and found that in the EEPROM area the content was changed. After reprogramm it to original the device works again but the repleted problem is still.

Does anyone who make this thing encounter the same problem and any correction to make it keep moving steady without the need to reprogrammed it often.

oep
2nd July, 2011, 06:18 PM
In case someone else gets this... its not working.