motometer dash golf 4

[sjonv]

hello, i have here a golf 4 sdi.

This car has burned engine wires, and also dash wires. I replaced new wires, and the ecu and instrument dash.

old dash motometer 1J0919861b

new dash motometer 1J0919860b

I tryed to get the motor running with the new cluster but it runs 1 second and than shut off. So it is the immo (also checked with vagcom.

i replaced the 24c02 in dash from old to the new one. Now it wil start, but al beeps and light flashes in the dash. Also km is changed in DEF. All meters dont work.

can somone help me to get it let run with the new chip in new cluster without problems with beeps and light?

thanks in advance

[peikman]

Still need a pin or input from the driver EDC15.

[sjonv]

is there not a way to disamble the immo?

[ricards99]

why disable im*o, this is the dump of the new dash with im*o data of the old one, pin ( of the car) 8901
km: 290000
try and reply

[peikman]

is there not a way to disamble the im*o?

Can be done but you need to make a change in the engine driver. I understand that this is EDC15?

[sjonv]

hello ricards. i tryed your software but that dont works. meters and beeps arre good now.

here is dump from 24c02, i think it is msa not edc15.

can you help me futher, ore someone else?

[ricards99]

if car dont work then you must program keys with vag k+can or supervag or vagdash, with the pin i give you

[sjonv]

oke i will try it monday. i lett you know how it goes with vag k+can.

thanks for helping!!

[umoussa]

I can Kill the Immo for this ECU, just send me the Bosch number: 0 281 XXX XXX

Thanks
Umoussa

[sjonv]

umoussa,

i wil repy tomorrow.



thanks

[sjonv]

to umoussa:

0281001759

038906013 1831


thanx in advance!

[sjonv]

hello guys, i did not succeed with vag k+can. Could not login to ecu or dash.

i used vas5054a, guided fault finding. i get some errors while using but it have work good. The car start with new cluster and ecu.

thanks to the guys here that tryed to help me!!


big thanks!!