Beverly 350 MIU G3 Immo off

[keles]

Hello to everyone, i have a problem with the ECU its Magnetti Marelli MIUG3 and the bike dosent start it gives error code with one 0.7seconds and second one 0.5 seconds blink from immobilizer light. From piaggio service manual it says that the cable is the problem that goes from the antenna to the ECU but it isnt because when i connect new virgin ECU the bike starts normally only 2000 rpm is the max since its virgin.
If someone can make IMMO OFF in this file i presume is the correct one from the ECU so i can try, the chip from which i read the data is 95320.

Thank you for your time.

[f2f2]

This solved ? If no need flash file post.

[keles]

This solved ? If no need flash file post.
Hello, nope i havent solved it....

[f2f2]

Then iaw guzzi soft collection find
(Red color miu g3 flash read soft)

[keles]

Then iaw guzzi soft collection find
(Red color miu g3 flash read soft)
Hello,

finally the cables arrived, am attaching the bin file, and i wouild like to ask if you could make the ecu virgin if not then please make immo off.
Thank you

[keles]

here is the ecu bin file

[gkogkolos]

here is the ecu bin file

1st you have to reset your ecu to virgin state.

2nd Write my file and start your engine.


Press Reputation +1 & Thanks buttons = Password in PM


regards

[Neil F]

I have a Moto Guzzi with MIuG3 ecu, is it possible for you to modify my file for Immo. off as well ?

[eprommazza]

i need immo off
thanks in advance

[f2f2]

i need immo off
thanks in advance
This solved ?

[eprommazza]

This solved ?

not yet......