Control checksum PLCC 32 Golf 4

[calibra1]

hello,
can you check if the checksum of this mod file is correct? (Golf 4 PLCC32 EDC15 driver 846) With the two modified chips the car does not start.
Thank you

[S0nda]

hello,
can you check if the checksum of this mod file is correct? (Golf 4 PLCC32 EDC15 driver 846) With the two modified chips the car does not start.
Thank you


checksums are ok, check ur soldering on board.

[reproteq]

here video a good job , add pinout for obd diagnose and test ecu.
https://youtu.be/xhKWg9CbCUs

[calibra1]

Hi, thanks for verifying.
The welds are OK, if I put the original chip the machine turns on, with chip mod it doesn't start even if I write the original file. Possible programming problem? I use TL866

[dpreprotechnik]

Hi, thanks for verifying.
The welds are OK, if I put the original chip the machine turns on, with chip mod it doesn't start even if I write the original file. Possible programming problem? I use TL866

Are your new rewritable chips compatible? If memory size is correct, just verify after writing. If cks is ok too, you should be good.

[calibra1]

Yes the rewritable chips have already been used.
I can't figure out what the problem is but I'm sure it's the checkusm.

[carbon7319]

965808

Your read is not ok and also mod is not ok.
Find your mistakes and all will be good.

[calibra1]

OK, tanks