peugeot 306 immo help

[holtzy]

Hy i need i**o off for peugeot 306 2.0hdi bosch EDC15c2 0281010249 i understand that te i**o is in 5p08 eeprom i dont know if i can read it whit willem and i think i need to desolder it to read thanks in advance

[gezame]

Hi
willem think, does not support 95p08.
Regards.

[holtzy]

thanks for your reply if i can read with another programmer will you help me to make i**o off?

[holtzy]

please help me I realy confuse what to do to start the car

[melcool]

please help me I realy confuse what to do to start the car

Buy a programmer that can read 95P08 (like UUSP (UPA-USB Serial Programmer) from elrasoft.com) ...read the 95P08 eeprom from engine ECU and post it here to make it immo off! :)

[holtzy]

melcool thanks for your reply if i purcase wellon VP-ISP1 is good for the job? because with upa usb i think i must wait too long for shipping and i need this programmer quick

[holtzy]

Buy a programmer that can read 95P08 (like UUSP (UPA-USB Serial Programmer) from elrasoft.com) ...read the 95P08 eeprom from engine ECU and post it here to make it im*o off! :)

True USB Willem Programmer is good for read? i must have adaptor for it or just the programmer?
MCUmall Electronics Inc. A low cost EPROM EEPROM Atmel PIC I2C SPI programmer online store (http://www.mcumall.com/comersus/store/comersus_viewItem.asp?idProduct=4282)

[benci1982]

immo off the easiest to pick up the eeprom,

[holtzy]

im*o off the easiest to pick up the eeprom,

True USB Willem or wellon vp-isp1 is good for this chip i think that both can read and write 5p08

[holtzy]

i have manage to read eeprom with GQ-4X

[melcool]

i have manage to read eeprom with GQ-4X

Are you sure that you have read it correct...anyway... try this and post results!

[raimi.s]

i have manage to read eeprom with GQ-4X


try this dump

[holtzy]

thanks for replies i try it tuesday and post result.
Happy Easter to everyone!!

[holtzy]

another question i must cut im*o wire?

[raimi.s]

no, no need for this car

[redmango55]

thanks to every one wants to make things easy and to every one here..

[marki]

Can someone confirm if we can really read and write epprom 95p08 with willem.Is it possible or not???

[looly]

I have a willem clone and that does not support the 95p08. You can get a partial read using the 95080 utility but it does not read all of the data. As others have mentioned it is best to buy a upa-usb programmer.

[holtzy]

not working i tried with both dump i got imobiliser data programing fault i read the ecu with kwp2000+ before i flash te dump in if this help i can put this dump here

[holtzy]

i managet to start the car thanks for your patience and help i found the dump on this forum is from a citroen xsara

[calin_bm]

give as a link to see where is the solution
thanks

[holtzy]

i use this file