Learn the key card

[Kurtkoeln]

Hello,

My 2 key cards are gone and I now have two identical cards with 3 keys, can I just replace the transponder and then learn them as in this video? In this video, he also learns cards because the vehicle didn’t have any.

Part 1. https://youtu.be/OahcHNiw91k

Part 2. https://youtu.be/wyXFK5hiFWU

Another video https://youtu.be/wyXFK5hiFWU

Now I have read this in this video here and how do I learn the locking? How do I get into the inner module / to do this.

Here is a small note about cars where someone has changed the so-called „start package“

The interior module, the motor ECU, the card and the steering column lock are used, come from

Another vehicle.

If these components have not been „shredded“ correctly

It is necessary to enter the VIN number that CLIP reads from the UCH module (cabin module) - NOT the VIN number of our vehicle.

The UCH originally comes from the vehicle, only the steering wheel lock / bolt lock is replaced due to the error message and the one used is reset.

What is the best way to learn cards?

Renault can clip?

DDT4ALL?

Renolink?

If I learn the maps about Renault Can Clip as in this video here, I will be shown at the end that the result is not satisfactory.

I go to the reserve, then I enter the number 5938, then I get the bytes for the ISK, I write down this number, then I open the Renault Pin Extractor and go to ISK, there select my vehicle and enter the number I received when visiting the reserve in the ISK field, and then click on ISK to

Then I go to Maps learn follow the instructions, card off click Next, Map in, click on another card yes and then another card in and the same other card no.

Then I get the Outcoude and call the Pin Extractor and go there to Clip, then I enter the Outcode, Vin, PIN code and have my incode calculated, then I enter on the page where the Outcode is above, and the Incode and click and then I get the message result not satisfactory.

After I have entered the incode on the Outcode page and clicked Next, do I have to insert the cards again and then click on Confirmation?

Because I don’t get the fields like in this video https://youtu.be/noJFvlJvLRY Minute 6:57

I did it like in the video,

Then reserve the bytes taken from 18 - 23.

So I have a Sagem in it, according to DDT4ALL & Renolink.

That’s on my UCH on it.

1

Date 071009 Heure 0646

Vehicule: Requisition:

4130411 0408

Faisceau: 82008 11977 G

MUH: — — — — —

UCH: 82006 60170

BFR: 82003 71619

Do I have to take it until 23 or 24?

And I also found that, if I can’t learn used cards, I can then simply delete them via EEProm (ch341a runs via EEProm) and then insert new transponders and learn them

I have collected and ordered enough programs and probes.

Renault Espace IV
2007