View Full Version : Ms41 328 e36 Tune REv limiter Pop bangs
techcar1992
3rd November, 2023, 09:07 AM
hi please tune pop bangs rev limiter my bmw e36 328 ms41 ecu
hw:1429861
sw:4101
thanks....
techcar1992
3rd November, 2023, 03:43 PM
anybody help??
Baddog84
3rd November, 2023, 03:53 PM
https://mega.nz/file/NOokEK6a
techcar1992
3rd November, 2023, 04:01 PM
thanks please pass
techcar1992
3rd November, 2023, 05:04 PM
thanks i try but not have popbangs and rev limiter very very slowly
Baddog84
3rd November, 2023, 05:38 PM
car have ac?
at what rpm is limiter?
techcar1992
3rd November, 2023, 06:31 PM
yes have ac and 6500rpm
techcar1992
3rd November, 2023, 06:31 PM
i try witc ac on off but not
erkor
3rd November, 2023, 07:42 PM
.....................:)
erkor
3rd November, 2023, 07:45 PM
Try this a file.
CAT must be removed !!!
Engine temperatur up 85.
MAX Rpm limit is 6800
]994202
techcar1992
3rd November, 2023, 08:26 PM
thanks erkor (https://www.digital-kaos.co.uk/forums/member.php/594022-erkor) please pass
erkor
3rd November, 2023, 08:38 PM
Thanks.
Check PM
techcar1992
4th November, 2023, 10:22 AM
thanks erkor again but not have fast rev limiter and pop and bangs..
Baddog84
4th November, 2023, 02:28 PM
yes have ac and 6500rpm
write not ok
rpm is higher
Baddog84
4th November, 2023, 02:29 PM
what tool you use?
erkor
4th November, 2023, 04:25 PM
jeszcze raz dziękuję erkorowi, ale nie mam szybkiego ograniczenia obrotów, popu i huku..
try this
...............................
techcar1992
6th November, 2023, 05:32 PM
i read with kess
peechie
7th November, 2023, 02:28 AM
If erkor's file isnt working i can make it for you, just dont want to make it if his is good :)
techcar1992
7th November, 2023, 01:57 PM
not work mate
erkor
7th November, 2023, 03:41 PM
Maybe Kess is not a good tool for this ECU. After writing a new file to the ECU, did you check whether the changes were saved correctly? Your file read by Kess is slightly different from the files I have. I give a file, a partial read of 24kb and new tool for work. You may need to write a new full flash file to the ECU, because the one read by Kess and flashed several times is wrong in the ECU. Try this:
994788
994789
994812
youfarid
9th November, 2023, 12:29 AM
read only the partial 24 KB file with k+dcan cable and (Siemens MS41 Flash Tool_105b) software then i will do a pop and bang and a very fast hard limiter
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.