uknown version

[metrolocknkeys]

ok guys i have a customer with a 2005 dodge caravan. the customer said she lost the key but when i try to program the key the programmer says successful but security light still blinking and the car starts and shuts right back off i pull the skim and read the 95040 eeprom and put it into tango i get unknown version i read it with vvdi prog and also ar32. my ar32 compared the file and said its a good file but nothing will accept the file i have attached the bin file as tc.zip

[camelgd]

Pacifica System- can be eepromed with IM508/608 or autopropad to get pin.

[metrolocknkeys]

Pacifica System- can be eepromed with IM508/608 or autopropad to get pin.
ok so i went to junk yard and got another skreem module and read it and it comes up in tango so it appears that the eeprom data is corrupted i can read 3 other skreems but this one i get unknown version

[vov4ik]

ok so i went to junk yard and got another skreem module and read it and it comes up in tango so it appears that the eeprom data is corrupted i can read 3 other skreems but this one i get unknown version

In some cases I had those older dodges equipped with aftermarket remote starter wired-in, which hindered learning. Just an idea to check on.


Sent from my iPhone using Tapatalk

[alex_r_2001]

You can try to edit vin in junkyard skim to match vin of van (I do not know if checksum applies to skim) and program key

If that does not work leave eeprom of donor skim intact and change vin in pcm to match donor skim ( it should start but with abs light on) & ( program key )

If you have drewtech passthru or snapon passthru you can use J2534 Toolbox 3 to disable skim in pcm ( need to leave skim disconnected from van )

If you have autel passthru or any other j2534 passthru you can use Chrysler APNT to disable skim in PCM
( cost alot but worth it I use it all the time) & ( must leave skim module disconnected)

https://youtu.be/bR3xQJD-d1Q?si=Qoaa-wL-eGclL7f-