Peugeot 206 BSI, eeprom programing

[Be gone]

From reading on this site it seems that I can replace the BSI by swapping the eeproms from one BSI to the other.
The BSI is a Siemens S105872400E, BSI T1, 9627137080 03, which eeprom holds the data.
I have a second hand BSI, but rather than just swapping the eeproms, would like to clone them, we have eeprom programmers at work, but what software do I need to read/write the eeprom's?
One of the enginners at work is going to repair the orginal unit for me, so I am hoping to just swap them back once the BSI has been repaired.

[Ashraf6119]

What's the problem with the car :questionmark:

Not starting :questionmark:

Ash

[Be gone]

The problems are there are no indicators and the electrice windows only work when the wipers are on, it starts ok.

I had the relays checked and they are all operating.

[joubliss]

u have to make the BSI Virgin and calculate the code from ur original BSI and Reprogramm it
dont swap the eeprom it will not work

[racin-snake]

has this one got coms 200 module ?
can we have more details inc fault codes ect ?

[adam28]

It does work if you swap eeprom, as i have done it more than once. Before i had PP2000.

[jnoroeste]

Hi m8, bsi are two boards, just replace relay board from second bsi to original one.Boards are not welded just pull up with care.
Regards.