ABS SANDERO2 TCE

[carloxgsxr]

I need to adapt the km of the ABS of Dacia Sandero 2019 REF-476605492R
It reads 158000 and I need 90000, it was updated to 158,000 km by putting another TDB marker.
I have Renolink and I read the TDB flash eprom but I can't read the ABS
Some help Thank you

[jomberykaso]

Your file has 152677 kms.

[carloxgsxr]

Your file has 152677 kms.
How can I read to change the ABS?
If I put 90,000 TDB but 152,000 ABS it will change to the highest, right?
Ecu + TDB if I can with Renolink
Thank you

[carloxgsxr]

Your file has 152677 kms.

Is there a way to put your flash with ABS lock?
I put it on and it is ok at 90,000 km but in the ABS I have 152,000 and it changes after 2 minutes
Thank you

[jomberykaso]

read abs...

[carloxgsxr]

To read the ABS I need to disassemble it and bleed the fluid later.
Is there a way to do it through OBD2 Renolink does not do it
Thank you

[jomberykaso]

To read the ABS I need to disassemble it and bleed the fluid later.
Is there a way to do it through OBD2 Renolink does not do it
Thank you

if you block abs from cluster flash file, then car will have a lot of problems. tested.

[carloxgsxr]

Some tool to read by obd2
Or is it better to disassemble ABS and read with Upa?
If I disassemble, do I only have to remove the electronic part so as not to remove the tubes or hydraulics
Thank you

[marina_rv]

Some tool to read by obd2


X-Tool
Smok
iProgPro
DP4
and other

or open ABS and read by programmer

[carloxgsxr]

I'm going to try to open the ABS without removing the hydraulics.
There is very little room in that Dacia Sandero car that goes wrong.
And read it with UPA
Thank you