Ford Mondeo BCM BG9T-14A073-EH

[elmaro]

Hi.

I have a dead BCM, number BG9T-14A073-EH, water damaged.
I don't have much experience with Fords and I'm asking for help.
What BCM numbers are interchangeable for this BCM?
What is the procedure for replacing the BCM in a car?
I have a SMOK UHDS with an IMMO Ford license.
Can I do it with this device? Do I need new keys?


Thanks

[ricked]

read this one in bdm and buy a BG9T-14A073-EH and program it in bdm or buy IO terminal

[elmaro]

The problem is that BCM number BG9T-14A073-EH is scarce.

[ricked]

Normaly you can buy a BG9T-14A073-xx and this will also work as long as BG9T-14A073 is the same

[elmaro]

I bought BCM BG9T-14A073-BH, but using cloning via BDM, not everything works correctly.

[clautosing]

Hello. I repair Ford cars and i had the same problem with a BCM with water. My problem was that i couldn't read the old BCM because was dead. I see that this BCM is for Mondeo Euro 5. To clone this BCM you need IO terminal or VVDI prog i think. You van use another code BG9T-14A073-xx but you have to do Module configuration or As built data. If you can't read old BCM you have to program it . You can use old keys.
I don't know what you can do with Smok tool with immo but i think is possible to program. You need to write keys and after this Module Initialisation as PCM, BCM, ABS

[elmaro]

I can read the old BCM. VVDI prog only reads, it is not possible to write this BCM. I read the flash, eeprom and data flash and programmed the new BCM using SMOK JTAG, but there is a problem with the windshield heated window button. Activates the trunk opening and turns off the ESP.

[clautosing]

I have the same problem. But i deactivated windshield from module configuration. I didn't find any solution. But i didn't have the same code, maybe with the same code you will not have this problem.

[elmaro]

The motherboard has a different element in the photo. It is not present in the original BCM. When I desoldered it, when I turn on the window heating, the engine turns off.