Please immo off iaw4mv bora 1.6 16v

[Peter2310]

Hi friends,
I´m fighting with a Bora 2001 1.6 16v. I needed to buy a second hand ECU and i can´t get start the car. Could you help me?

Magneti Marelli
036906034 BH
IAW4MV.F

Thanks in advance!

[Ninjor s]

Hi friends,
I´m fighting with a Bora 2001 1.6 16v. I needed to buy a second hand ECU and i can´t get start the car. Could you help me?

Magneti Marelli
036906034 BH
IAW4MV.F

Thanks in advance!

remove eeprom out the board and read it{reading dont look good to me}.
or use this

[Peter2310]

Thanks a lot Ninjor s. I read the eeprom out of the board, but I guess it´s not a good read.
I will try again, and if I can´t get a good one I will use the file you recommend. I will report the result.

Regards!

[Ninjor s]

Thanks a lot Ninjor s. I read the eeprom out of the board, but I guess it´s not a good read.
I will try again, and if I can´t get a good one I will use the file you recommend. I will report de result.

Regards!

...........pass sent.

[Peter2310]

Hi friends. I continue fighting with the car. I used the immo off file that you recommended and the car starts but now I have another problem. In a minute after start the idle speed goes to 1100 rpm and the car goes into "save mode". It can´t go over 2500 rpm.
I can´t read the engine module with obd (it´s not a new issue, with the old ECU i couldn´t do it either). Do you think it could be a problem due to using a non-original file from this ECU? Or maybe this is a faulty unit (it´s a second hand one)

Thanks in advance. Regards

[aboelgood]

..............................

[Peter2310]

..............................

Thanks friend. Then, do you think it´s a problem with the file that I used?