PDA

View Full Version : JAGUAR S type



avtonega
10th April, 2010, 11:48 AM
Hi

I have a problem with Jaguar S type 3.0 175kw

Engine cannot start/crank, message on board, gearbox fault, and dtc in engine ecu

Any idea what to do?

Meat-Head
10th April, 2010, 01:06 PM
not sure which Shaguar it is, but one of them has the gearbox ecu in the trunk.

Hopefully the battery has expelled enough acid to make to car beyond ANY repair.

As it's an auto, you won't be able to notice the shape of the gear knob, looks like 'ET's head.

Loom has proberbly gone rotten under the front bumber area

bonecrusher
10th April, 2010, 01:29 PM
Hello
I see that you are using bosch kts.I have the same and it is utterly useless on Jaguar.I had a s-type in the shop a few months back also with gearbox fault errors and misfire but the engine did crank and start.To cut a long story short we found faults with the ECU.Got a second hand unit,fitted it in and had to send it to agents for transponder coding,perfect after that.

oldford
10th April, 2010, 02:07 PM
You can ignore P1000. That's not an error. It's information only that not all of the EOBD monitors have completed their test. It is always set when you clear the codes.
P1643 - CAN Link Engine Control Module/Transmission Control Module Circuit/Network
Source: Diagnostic Trouble Code Library (http://www.eobd2.eu/DTCL.asp)
Could be wiring or connectors or an internal fault in the engine or transmission ecu.

avtonega
10th April, 2010, 04:31 PM
Does anybody know where are ECU locations in this viechle?

Brand of ECU?

cristec
10th April, 2010, 04:39 PM
Jaguar 99-04 wiring diagrams and component locations here Jaguar electrical reference (http://www.captainjaguarscathouse.com/Electrical_Reference.htm)

HTH

avtonega
10th April, 2010, 08:00 PM
I have found crank relay then open it and join contacts.
Engine started immediately, gearbox works fine (tested in parking area)

There is message on dashboard : gearbox fault

I think I have a problem with gearbox TCU?! But TCU is inside gearbox?!

Any idea what to do next? Anyone?
This is my first time work with Jaguar

bonecrusher
10th April, 2010, 11:00 PM
transmission control unit built into engine control unit

Albanais
10th April, 2010, 11:30 PM
Change your brake switch matte

avtonega
11th April, 2010, 01:36 AM
Solved:manutop:

Car was crashed...

nutloose
11th April, 2010, 02:32 AM
not sure which Shaguar it is, but one of them has the gearbox ecu in the trunk.

Hopefully the battery has expelled enough acid to make to car beyond ANY repair.

As it's an auto, you won't be able to notice the shape of the gear knob, looks like 'ET's head.

Loom has proberbly gone rotten under the front bumber area

Right first reply I think.

good call MH
I've seen a few ABS faults in there too

Meat-Head
11th April, 2010, 08:21 AM
Solved:manutop:

Car was crashed...

That's one way of sorting the job. Just crash it, must remember that one

Thanks for the photo

autotrans
14th April, 2010, 01:48 PM
S type jaguar later 6 speed zf transmission ecu built into
transmission.
early 5 speed transmissions 5R55N use engine ecu