PDA

View Full Version : DELPHI DCM 3.2AP SSANYONG REXTON IMMO OFF HELP


ngakson2002
8th July, 2024, 07:20 AM
Hello Friend
Please need help for a Good tested immo off solution for a SSANYONG REXTON ECU DELPHI DCM3.2AP EEPROM Read as ST95320. I did the immo off with IPROG+ Clone SW 85; The engine start and Idle pretty well but upon acceleration Revolution Will not go beyong 2000 RPM.Could this be a problem of Checksum? I have attached both the Original dump and the immo off dump processed with IPROG+

Kind Regards
elektronik325
8th July, 2024, 10:15 AM
Your immo off. Thx+Rep=Pass Pm
ngakson2002
24th July, 2024, 05:57 PM
Your immo off. Thx+Rep=Pass Pm

Hello Mate;
Tested the your off solution today and no change:In fact, the engine start at rotated at 1000 RPM and there is NO THROTTLE RESPOND
I Scanned the ECU and one of the DTC is Variant Coding Error. Please any other solution?

Best Regards
jomberykaso
24th July, 2024, 06:30 PM
Hi, write this file in "bin" instead of "hex".

Disconnect antenna coil and start the car, pass in pm.
elektronik325
24th July, 2024, 09:47 PM
Hello Mate;
Tested the your off solution today and no change:In fact, the engine start at rotated at 1000 RPM and there is NO THROTTLE RESPOND
I Scanned the ECU and one of the DTC is Variant Coding Error. Please any other solution?

Best Regards

Hi. The solution is 100%. the ECU configuration remains the same as it was. I didn't have such a problem. Are you sure that the problem in the car is on the immo side? Eeprom was ori? Maybe it's damaged. Check if your injectors are coded? Maybe there's a problem here. Best regards