remote control vw to vag-com

[plays]

hello sameone know the procedure to coding new or older remote control for vw whith vag-com??? thanks

[Fallen]

For pre CAN cars you don't need vag-com to enroll remotes, it's a manual procedure.



1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the drivers door using a second key.
3. Using the remote control press the unlock button once, and the horn will sound
once.
4. Wait 6 seconds and press the unlock button once to activate the coding procedure.
The remote control will now be programmed.
NOTE : When performing programming on additional remotes the procedure is the
same, except you press the unlock button 2, 3 or 4 times for the different remote.
For example : If programming 2 remotes press the unlock button twice with a 1 second
interval between each press, repeat for 3 and 4 remotes.
5. Switch Ignition OFF.
6. Remove key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional remotes.
8. The ignition must be switched OFF between programming each remote control.