Egr Sprinter 906 om642 EDC17CP10

[lucioantonio]

I have this error in diagnosis 148C00 (p0405), (p0487) 149A00.tried more than one tuner to disable the egr valve without success. do you have a tested solution?
ecu bosch edc17cp10 ,engine recovery

[stephane76700]

Hi, try this!
No pass ;)

[lucioantonio]

Not work same problem

[bogdy]

1040693 here,pass in PM,don t forget THX+REP

[lucioantonio]

Bogdy ,thanks but not work same problem anomaly light enine flashed after start engine in ecu have 148C00 and 149A00 or p0405,p487 ,

[bogdy]

I check the file again and send it to you

[bogdy]

1040758 here the same pass disconnect egr plug

[lucioantonio]

I tried with your second file with the connector disconnected but the error is permanent I always have 149A00 or in generic obd p0405 maybe on this ecu it can't be eliminated?

[johak]

try this...

[lucioantonio]

iohak not work same problem,It must be complicated to remove, many have tried without success

[johak]

iohak not work same problem,It must be complicated to remove, many have tried without success

how come it doesn't work? do you have the same dtc? It takes time for these dtc's to clear. need 1 or 2 engine warm up and cool down cycles

[lucioantonio]

anomaly flashes once the engine is started, can you explain to me how to delete them?

[johak]

start the engine let it run for 10-15 min then let it cool. repeat if necessary or just drive normally and tomorrow they should be gone

[johak]

in the end, do you now have DTC or is it just the light flashing?

[lucioantonio]

i try let's hope so

[lucioantonio]

thanks for your help, problem solved, you don't have to modify the external file but the internal flash one, anomalies disappeared as soon as the file was written

[bogdy]

I modified what you sent and where did I find those problems, now external these original?

[johak]

you provide 1 file, we have no way of knowing that you are only writing half of it. this part that does not contain tables. which tool are you using?