vampro
5th December, 2024, 06:11 PM
Hello friends I am looking for a solution for this 2008 Subaru Outback 3.0
ECU Denso 22611AN370 112300-7970 plastic case
This Subaru crashed with the dtc p1572 IMM CIRCUIT FAIL .. so I couldn't find any solution I changed the key antenna, changed the immobilizer module and well it couldn't be programmed ..
Now I'm looking for a solution to turn off the immo on this car
Searching on the internet I found some websites where they did the immo off of the mcu sh7058 .. I spoke to a person and he sent me the off and I connected the engine ecu to the car and it worked .. the car started at last .. but the problem is now that the car after being running for a while, for example about 10 minutes approx. it won't start again ... so I said it crashed again .. I re-read the ecu .. compare the file with the off and everything is the same nothing was modified .. then I said the eeprom that it has is a 93c56 .. and yes there were some things changed .. but I did not believe that was the problem ... because I had the info before modifying the ecu .. I reloaded the original eeprom and the car still did not turn on .. now what is happening if the mcu info is the same as the off .. I rewrote the immo off in the ecu again .. and the car turned on again ..
so what is the problem .. disconnect the immo box ..
looking for a diagram I have a subaru diagram but some things change this subaru is 2008 ... and most suabru from 2003 to 2009 same branch same color except the one I have .. there are several things that are the same in the branch it says in the diagram that the immo pins are 2 that reach the engine ECU are not on the pins, those pins are not there, it's empty...
Has anyone of you, my friend, been through something like this?
ECU Denso 22611AN370 112300-7970 plastic case
This Subaru crashed with the dtc p1572 IMM CIRCUIT FAIL .. so I couldn't find any solution I changed the key antenna, changed the immobilizer module and well it couldn't be programmed ..
Now I'm looking for a solution to turn off the immo on this car
Searching on the internet I found some websites where they did the immo off of the mcu sh7058 .. I spoke to a person and he sent me the off and I connected the engine ecu to the car and it worked .. the car started at last .. but the problem is now that the car after being running for a while, for example about 10 minutes approx. it won't start again ... so I said it crashed again .. I re-read the ecu .. compare the file with the off and everything is the same nothing was modified .. then I said the eeprom that it has is a 93c56 .. and yes there were some things changed .. but I did not believe that was the problem ... because I had the info before modifying the ecu .. I reloaded the original eeprom and the car still did not turn on .. now what is happening if the mcu info is the same as the off .. I rewrote the immo off in the ecu again .. and the car turned on again ..
so what is the problem .. disconnect the immo box ..
looking for a diagram I have a subaru diagram but some things change this subaru is 2008 ... and most suabru from 2003 to 2009 same branch same color except the one I have .. there are several things that are the same in the branch it says in the diagram that the immo pins are 2 that reach the engine ECU are not on the pins, those pins are not there, it's empty...
Has anyone of you, my friend, been through something like this?