FRM3 repair with smok

[mihaiti]

Hello, i have succeded to read D flash, generated eeprom, but when write eeprom, at check the file does not match with my eeprom file. Someone told me to write partition but i cannot find it in smok prog. Did someone used smok Prog to repair frm?
Thx!
In Multiprog i have selected MC9S12XE EEE USEC
Program Adress Range Start Adress 000 End Adress 000FFF. This is the only option i have on Smok.
Read is ok of Dflash i have tested.
Help button takes me to picture folder and foud the frm i guess is supported!

[wuza]

Don't know about smoke but multiprog (xhorse) should read eeprom and flash data from bmw frm3 module fine...
I have done cloning with vvdi prog few times and i did worked fine...

Have you tried to repair your frm3 file with dutch website? I mean the web site from tomvan...nl...?

[dimitar]

Don't know about smoke but multiprog (xhorse) should read eeprom and flash data from bmw frm3 module fine...
I have done cloning with vvdi prog few times and i did worked fine...

Have you tried to repair your frm3 file with dutch website? I mean the web site from tomvan...nl...?

Multiprog????????
Are you sure???????
This hardware is in development phase still!!!!!
90% of the functions have bug ...DONT WORK..
Already tested
Do not rely on this piece of equipment screwed up cas 3 .......Rover BMS spc5506 mpc. .....honda airbag 2021 latest renesas mcu ~~~~ed up completely.............NO WORDS......Stay away from this piece of shit guys

[dimitar]

Cant remember all the screw ups with this shit ........will make videos as a prove so others can see what they are dealing with

[dimitar]

1000€ flushed:smile:

[opv]

FRM3 repair with smok eeprom writing procedure

After reading MC9s12XE D-Flash unesc and after generating the correct eeprom go to:
MC9S12XEP Config UNSEC

1. Read MC9S12XEP Config UNSEC
read should be
00 00 00 00 00 00 00 10
2 Set Config to
00 00 00 00 00 10 00 10
3.Write Config and verify
should be OK
4 Go to 9S12XE EEE UNSEC
read and verify should be OK for the value $FF
5.Load the generated eeprom file and do write and verify
FRM3 should work