Mercedes EDC16CP36 exhaust backpressure sensors off

[CARSYSTEM500]

Hello everyone!


In my mercedes s420cdi i deleted CAT DPF and EGR.
Ecu software was remap by good reputable tuner.
Both EGR plug, DPF temp. and differential sensors are disconnected.
Car runs fine witch no problem.


During service and replace several gasket seal i installed EGR block off plate.
After that B60/1 and b60/2 exhaust back pressure sensors has constant parameters (atmospheric pressure)
Car goes into limp mode witch fault code.
EDC16CP36 reed bdm witch k-tag.


I need disable B60/1 B60/2 from ECU.


Can someone help?

1063085

[Krisfuzzy]

Hello everyone!


In my mercedes s420cdi i deleted CAT DPF and EGR.
Ecu software was remap by good reputable tuner.
Both EGR plug, DPF temp. and differential sensors are disconnected.
Car runs fine witch no problem.


During service and replace several gasket seal i installed EGR block off plate.
After that B60/1 and b60/2 exhaust back pressure sensors has constant parameters (atmospheric pressure)
Car goes into limp mode witch fault code.
EDC16CP36 reed bdm witch k-tag.


I need disable B60/1 B60/2 from ECU.


Can someone help?Post dtc read from car

[introcrack]

here you go your dtc is off now




Thanks + Rep = Pass<3